In the photovoltaic effect, light generates electricity by creating a charge imbalance after knocking electrons out of atoms in the semiconducting materials of solar cells.

Solar energy alone can fully power the world if transmission hurdles can be resolved

When light strikes a photovoltaic cell, electrons are loosened, which travel through a circuit where the energy can be used. Distributing energy from high solar intensity regions and storing energy for non-daylight hours is logistically challenging and costly.

Electricity is produced when the ends of a battery are connected by a conducting wire, triggering chemical reactions that release the energy stored in chemical bonds.

Unlike solar panels, which convert sunlight directly into electricity, concentrated solar power systems focus sunlight to heat a material that boils water, which then drives a turbine-generator to produce electricity.

Solar panels can create pollinator-friendly habitats by protecting flowering plants

An example of agrivoltaics, where land is used for solar energy production and agriculture, the panels provide clean energy while also shading plants from excessive sunlight. Pollinator-friendly plants can improve water quality and reduce soil erosion by obstructing the wind.

Solar power is converting the sun's energy into thermal or electrical energy

Solar energy is the most abundant renewable energy resource. It can be captured in photovoltaic cells to generate electricity, solar heating and cooling technologies for temperature control, and concentrated solar power to drive steam turbines.

Solar panel manufacturing begins with silicon extracted from sand

The silicon is purified and shaped into wafers less than 0.2 millimeters thick, coated and connected through a criss-cross pattern of narrow and wider metal, followed by multiple rounds of lamination before bonding to a weatherproof panel.

Sand 'batteries' can store excess electricity from the power grid as thermal energy

Energy collected from solar or wind power is used to heat insulated silos full of sand to temperatures as high as 450 degrees Celsius (842 degrees Fahrenheit), which can be retained for long periods. These thermal energy storage systems can be designed to boil water and generate electricity when needed.

Solar sails use light as a means of propulsion

Photons possess momentum and can transfer it to objects they strike or bounce off, imparting radiative pressure, or a light-based force over a small surface area. Lasers fired at observational equipment with specially designed sails can theoretically use this mechanism to accelerate up to 20% the speed of light.

Larger shares of solar power generation produce larger energy demand curves

Because solar energy is only available during daylight hours, transitioning an electric grid to solar requires significant ramp-ups and ramp-downs of other energy sources during mornings and evenings to compensate. Widespread adoption of affordable energy storage solutions can soften these curves.

Electrogenic animals generate their own electricity within an electric organ by changing the pattern of electrical charges in disc-shaped cells called electrocytes.

A 1,000 square kilometer patch of solar panels in Africa can power most of Europe

The $500 billion Desertec initiative would have constructed massive solar farms in the Sahara and expansive electrical transmission networks across continents. However, the plan was built on concentrated solar power technology, which is more expensive and less practical than photovoltaics.

If two strands of conducting materials are connected at two junctions, electricity can be generated if one junction is heated while the other is cooled—a phenomenon known as the Seebeck effect.

Space-based solar power systems may beam energy to Earth

Researchers have successfully collected power from solar panels on a plane and transmitted it to a receiver on Earth's surface, achieving a milestone for space-based energy. The proof of concept is a precursor for a satellite-based solar farm that would transmit energy 24 hours a day.

Hydrogen fuel cells, which combine hydrogen and oxygen to generate electricity and water, can be run in reverse to produce hydrogen fuel from water.

The first practical silicon solar cell was developed at Bell Labs

In 1953, scientists at Bell Labs attempted to develop a power source for phone systems in remote locations, as the dry battery cells lacked the necessary longevity. They experimented with solar power, but the selenium solar cells of the time were too inefficient, eventually leading to the usage of silicon.

Lightning rods provide a conductive pathway to safely steer massive electric currents

The device is positioned higher above the ground to "catch" one of the many branching filaments of electrons from clouds before they make contact with other surface structures, which have been induced to have a positive charge by overhead storm clouds. The current is then sent to a conductive grid buried underground.

In osmotic power systems, the natural movement of water from regions of low to high salt concentration is used to generate electricity from pressurized water.

Interactions between solar storms and Earth's magnetic field create auroras

Solar storms on the Sun's surface produce clouds of electrically charged particles, some of which make their way to Earth. Those trapped in Earth's magnetic field accelerate toward the north and south poles, colliding with atmospheric atoms and molecules in the process, which produces light.

View an interactive chart of energy conversion efficiencies for various photovoltaics

This National Renewable Energy Laboratory visualization provides maximum confirmed efficiencies for nearly 30 research PV cell technologies from August 1975 to today. Concentrator multi-junction cells have led the field since 1993. (Desktop recommended site.)

The first rooftop solar panels were installed in 1883

In 1883, New York inventor Charles Fritts created the first solar cell by coating selenium with a thin layer of gold. The cell achieved energy conversion rates of 1 to 2% compared to the 15 to 20% of modern photovoltaics.

The chlorophyll in plants captures energy in the form of red and blue light

Light-dependent reactions during photosynthesis convert sunlight into chemical energy, stored within the bonds of molecules such as ATP and NADPH. Rather than being absorbed for these reactions, most green light is reflected, causing most plants to appear green.

On average, the human body produces about 100 watts of electricity—enough to power a light bulb—but some people can produce over 2,000 watts in short bursts, such as when sprinting.

An overview of oxygenic photosynthesis, which releases oxygen from breaking down water

Within the membranes of chloroplasts, electrons in pigments are energized by light and transferred across a series of molecules until they create the energetic NADPH molecule. This transfer also powers a hydrogen pump, which creates an ion imbalance that, when relieved, produces energetic ATP molecules. Outside the membranes, both NADPH and ATP are used to synthesize G3Ps, which are funneled into other metabolic pathways to produce sugars.

The sun emits a continuous stream of plasma known as the solar wind

Composed of charged particles—electrons and ions—the solar wind is deflected around the Earth by the planet's magnetic field. More powerful solar storms, known as coronal mass ejections, are short-lived but produce huge clouds of plasma that disrupt technology upon reaching Earth.

More batteries in the power grid would create an on-demand energy reservoir

Most power grids are inefficient because they require enough generation capacity at all times to avoid blackouts. This means at any given time, as much as 50% of generating capacity at power plants can go unused. Batteries would reduce this inefficiency and allow for real-time adjustments.

How artificial photosynthesis can help make plastics and fuels using sunlight

These systems link a molecular light absorber to a catalyst that can synthesize fuels—such as ethanol—and ethylene, a precursor to plastics, in a carbon-neutral manner. Because these byproducts have greater energy concentrations than the carbohydrates produced by photosynthetic organisms, research is ongoing to engineer the necessary catalysts.

The world's largest lemon battery was made from nearly 3,000 lemons

By connecting lemons with a piece of zinc on one side and a piece of copper on the other, a team from the Royal Society of Chemistry created a fruit battery with a capacity of 2,307.8 volts.

Enough sunlight hits Earth in just 90 minutes to power the planet for an entire year

Despite this, in 2023, only 5.1% of electricity in the US came from solar energy. Solar panel technology has nonetheless made significant advancements since the 19th century, largely due to NASA's efforts in the space race.

Electric grids that rely on solar power must compensate for reduced electricity generation during solar eclipses.

Most advanced touch screens rely on electrical charge in your skin

Capacitive touch screens store electrical charges in an electrostatic grid of tiny wires. When we touch the screen a tiny electrical charge is transferred from the screen to the finger to complete a circuit (since skin has positive and negative charges). This connection creates a voltage drop on that point of the screen. Cloth, however, doesn't conduct electricity, which is why humans can't wear thick gloves and operate their smartphones.

Photoautotrophs, which include plants, algae, bacteria, and Euglena, are organisms at the base of the food web that convert light energy from the sun into chemical energy stored in sugars.

Lightning is the sudden flow of electricity in the atmosphere as two oppositely charged regions seek to become balanced via the movement of electrons.

Lightning forms when streams of rising and falling charged particles connect

In cloud-to-ground lightning, a buildup of negative charge at the bottom of clouds repels electrons on Earth's surface, leaving behind positively charged particles. When descending negatively charged air—the stepped leader—meets rising positively charged particles—the upward streamer—brightening runs up the connection, producing intense flashes known as return strokes.

Some renewable energy sources may weaken the resiliency of electric grids by removing outage buffers provided by coal- and natural gas-fired plants, which provide the system with more time to find a new power source if a plant goes down.

Lasers help build the layers of circuit components in microchips

During the photolithography process, light is projected through a blueprint onto a light-sensitive chemical layer on silicon wafers, etching patterns that become transistors through a series of successive reactions. These processes require significant electricity, as only about 2% of photons reach the wafer.

Watch a timeline of the history of electricity, from observations of static electricity in antiquity to the War of the Currents—a rivalry to establish the ideal system for electric grids.

Visualize how alternating currents—electricity that periodically changes direction—are generated by rotating magnetic fields, as occurs in turbine-generator systems.

Rain-catching tubes provide new hydropower source for tropical regions

An experiment in Singapore showed that charge separation could be established by rainwater flowing through narrow tubes. The separation, which creates a voltage, could be scaled up in regions of high rainfall to provide a clean energy source.

Agrivoltaic solutions are tested in the land around the Biosphere 2 complex

The experiments involve identifying conditions needed to grow plants beneath solar panels, which protect the plants from the harsh sunlight of the Arizona desert. Research includes a citizen science component, where satellite gardens have been installed in nearby high schools.

Clean energy technologies are more mineral-intensive than burning fossil fuels

Solar panels use silver due to its high conductivity, hydropower plants use chromium in their steel alloys, and geothermal plants need titanium to withstand abundant heat and pressure. Lithium—used in energy storage—is expected to see over 500% increased demand from 2020 to 2025.

Watch lightning strike a building at 40,000 frames per second

When the built-up layer of negative charge at the bottom of clouds is sufficiently high, a network of charge filaments will emerge. If one of the filaments meets a rising strand of positively charged particles, a highly conductive path forms, and charges across all filaments move to the path, generating lightning

NASA's guide to solar flares and how they work

Flares happen when the powerful magnetic fields in and around the sun reconnect. They're usually associated with active regions, and carry the potential to disrupt electronics on Earth.

The characteristic zigzag of lightning originates from columns of conductive oxygen

Energized electrons from the base of clouds collide with oxygen molecules, placing them in a "singlet delta state," which makes the air conductive. Collisions continue until more than 1% of nearby oxygen is in this state—about 0.00005 seconds—matching the electrical potential of the cloud and propogating electricity in a 50-meter "step."

Genetically modified viruses can help construct battery electrodes

MIT scientists' modifications caused the viruses to attract conductive materials, such as gold ions, which the viruses self-assembled into nanowires that could be used in batteries. These components allow batteries to be thinner and flexible enough to be constructed into new shapes.

Wireless charging uses a magnetic field to move charged particles in a battery

Based on the concept of electromagnetic induction, when a compatible device is placed on a charging pad with correct alignment, the alternating current flowing through the pad creates a changing magnetic field. This magnetic field induces a current in the device, recharging the battery without a connecting wire.

Explore global solar resources with this interactive map

One of the biggest challenges to deploying solar panels is whether electricity can be generated reliably when needed, day after day. This detailed interactive map calculates the solar power output potential of regions worldwide and provides a visual comparison between locations such as North Africa and the US Midwest.

This online magazine runs on a solar panel, sometimes going offline

The publication's solar-powered server in Barcelona means the site goes dark when clouds roll in. It's designed as an intentional statement about energy and digital infrastructure. The magazine features essays advocating for the adoption of pre-industrial or low-energy solutions to modern problems.

Transformers change the current and voltage across a set of wires by wrapping them around a magnetic core and using the magnetic field of one wire to induce a current in the other.

Learn why electrical substations are needed to provide safe electricity with minimal energy loss

These typically fenced-off facilities with steel boxes or cylinders topped with cone-like caps house circuit breakers, fuses, and switches that can isolate sections of the grid to prevent electrical failures from spreading. Substations use transformers to modify electrical voltage and are customized to the generation, transmission, and distribution networks they interconnect.

Watch how metals are extracted from rechargeable devices during recycling

Recyclable batteries found in cars, phones, power tools, and other electronics contain lithium, cobalt, nickel, and other precious metals, whose reuse generates 70% fewer emissions than during their initial mining. Upon shredding these devices, a filter press squeezes the pieces through a proprietary fluid, which separates them for future reuse.