Sand 'batteries' can store excess electricity from the power grid as thermal energy

Geothermal power plants can provide large-scale energy storage for other systems

These facilities can store excess energy from solar and wind power as hot water or steam, which can be used to run turbines to generate electricity when other renewable energy sources are unavailable. Simulations have found efficiencies of 90% during a storage-use cycle, making it comparable to lithium-ion batteries.

Geothermal power can generate electricity and provide direct heating for homes

By drilling several kilometers through penetrable rock, wells can access highly pressurized groundwater warmed by thermal energy trapped beneath Earth's surface. This water can be turned into steam to create electricity in generators. Heating systems several meters deep can pump fluid underground before circulating it through buildings.

Aquifer thermal energy storage systems bank water heated during the summer in aquifers—layers of porous rock, gravel, and sand filled with groundwater—which are then collected in winter to warm homes.

Unlike solar panels, which convert sunlight directly into electricity, concentrated solar power systems focus sunlight to heat a material that boils water, which then drives a turbine-generator to produce electricity.

Solid-state batteries substitute the fluid electrolyte layer with a solid

The non-flammable solid greatly reduces the risk of fire and explosion, as well as the release of toxic gases via leaks in the existing sulfide-based systems. These batteries use garnet-type solid electrolytes, which provide high ionic conductivity and chemical stability but require temperatures above 1,000 degrees Celsius (1,800 degrees Fahrenheit) for fabrication.

In osmotic power systems, the natural movement of water from regions of low to high salt concentration is used to generate electricity from pressurized water.

Some geothermal power plants make electricity using a secondary fluid

Direct dry-steam systems pull underground steam into a turbine-generator system, while flash and double-flash cycle systems spray extracted liquid water into a low-pressure tank, causing it to rapidly vaporize—"flash"—before moving to the turbine. Binary cycle systems use the extracted steam and water to flash a second fluid that easily boils, which then drives the turbine.

More batteries in the power grid would create an on-demand energy reservoir

Most power grids are inefficient because they require enough generation capacity at all times to avoid blackouts. This means at any given time, as much as 50% of generating capacity at power plants can go unused. Batteries would reduce this inefficiency and allow for real-time adjustments.

Clean energy technologies are more mineral-intensive than burning fossil fuels

Solar panels use silver due to its high conductivity, hydropower plants use chromium in their steel alloys, and geothermal plants need titanium to withstand abundant heat and pressure. Lithium—used in energy storage—is expected to see over 500% increased demand from 2020 to 2025.

Geothermal power can be used beyond heating and energy production

Depending on the depth of the natural vents or artificial wells drilled, the surrounding fluid temperature will vary greatly—from 10 to 371 degrees Celsius (50 to 700 degrees Fahrenheit)—allowing for various applications, including the drying of cement, concrete, and lumber, as well as the processing of pulp and paper.

Larger shares of solar power generation produce larger energy demand curves

Because solar energy is only available during daylight hours, transitioning an electric grid to solar requires significant ramp-ups and ramp-downs of other energy sources during mornings and evenings to compensate. Widespread adoption of affordable energy storage solutions can soften these curves.

In the photovoltaic effect, light generates electricity by creating a charge imbalance after knocking electrons out of atoms in the semiconducting materials of solar cells.

Solar power is converting the sun's energy into thermal or electrical energy

Solar energy is the most abundant renewable energy resource. It can be captured in photovoltaic cells to generate electricity, solar heating and cooling technologies for temperature control, and concentrated solar power to drive steam turbines.

Some renewable energy sources may weaken the resiliency of electric grids by removing outage buffers provided by coal- and natural gas-fired plants, which provide the system with more time to find a new power source if a plant goes down.

Solar energy alone can fully power the world if transmission hurdles can be resolved

When light strikes a photovoltaic cell, electrons are loosened, which travel through a circuit where the energy can be used. Distributing energy from high solar intensity regions and storing energy for non-daylight hours is logistically challenging and costly.

A 1,000 square kilometer patch of solar panels in Africa can power most of Europe

The $500 billion Desertec initiative would have constructed massive solar farms in the Sahara and expansive electrical transmission networks across continents. However, the plan was built on concentrated solar power technology, which is more expensive and less practical than photovoltaics.

Solar panel manufacturing begins with silicon extracted from sand

The silicon is purified and shaped into wafers less than 0.2 millimeters thick, coated and connected through a criss-cross pattern of narrow and wider metal, followed by multiple rounds of lamination before bonding to a weatherproof panel.

As of 2022, just 0.5% of installed renewable energy capacity worldwide is geothermal

Despite being able to generate electricity regardless of the weather, solar (28%) and wind (27%) are far more prevalent, primarily because of their lower upfront costs. Geothermal plants use 88% less space than solar farms to produce the same energy, but have been restricted to geologically active regions.

Fracking technology can help make geothermal power possible almost everywhere

Generating electricity from Earth's thermal energy has previously required existing underground reservoirs of hot water and permeable rocks through which the fluid naturally escapes. Today, fractures can be artificially created to form fluid pathways, and surface water can be injected underground and brought back to the surface.

Carbon-neutral data centers may be possible if built within wind turbines

Wind turbine towers are typically hollow, housing only cables and a ladder for maintenance access. The excess electricity a wind turbine collects could power a stack of server racks more than 100 meters (328 feet) high within its tower.

Wind energy is categorized into land-based, distributed, and offshore types

Distributed wind turbines efficiently serve on-site energy needs, while land-based turbines are large and generate cost-competitive electricity. Offshore wind turbines capture powerful winds above the ocean and may be pounded into the seafloor using pile drivers or built to float above water at scales larger than the Statue of Liberty.

Wastewater from geothermal power plants helps melt sidewalk snow in Iceland

Located on the Mid-Atlantic ridge, where the North American and Eurasian tectonic plates move apart, the nation saw geothermal power meet more than 90% of its heating demand in 2024. After the hot water produced by these plants is used to heat homes and businesses, it is transferred through small pipes beneath Reykjavík's sidewalks.

The abundance of raw materials may lead to sodium replacing lithium in batteries

Lower risks of thermal runaway, which can lead to fires and explosions, and less energy capacity loss at low temperatures support the shift. However, sodium's greater weight and lower energy density compared to lithium have made it best suited for stationary storage applications. (Some readers may experience a paywall.)

Desalination involves costly, energy-intensive methods for producing freshwater

Thermal desalination heats saltwater to produce steam, and reverse osmosis forces saltwater through a membrane that only allows water through. In both cases, freshwater is collected and remineralized for consumption, while wastewater brine is often returned to the ocean, where it may harm marine organisms.

The first practical silicon solar cell was developed at Bell Labs

In 1953, scientists at Bell Labs attempted to develop a power source for phone systems in remote locations, as the dry battery cells lacked the necessary longevity. They experimented with solar power, but the selenium solar cells of the time were too inefficient, eventually leading to the usage of silicon.

Data centers can be kept cool by circulating fluid over plates atop high-temperature components or by submerging equipment in non-corrosive oil that does not conduct electricity.

Benjamin Franklin described a series of static electricity storage jars as 'batteries'

Discovered over 50 years before the first electrochemical cell was invented, Leyden jars stored electric charge between the metals inside and outside a liquid-filled container. Franklin was the first to use the term "battery" in an electrical sense, though his multiple-jar device—lacking chemical reactions—was actually a series of capacitors.

Heat pumps use an easily boilable chemical to regulate temperature

In air conditioners, warm air is pulled from a home to turn a refrigerant into a gas, which is then compressed, raising its temperature. The gas naturally releases this energy to the comparatively cooler environment when exposed, then expands and is reused in the system. Heaters run in reverse, with the refrigerant picking up energy from the comparatively warmer environment.

Enhanced geothermal power systems can trigger earthquakes by injecting fluid into rock, increasing subterranean pressure.

Solar panels can create pollinator-friendly habitats by protecting flowering plants

An example of agrivoltaics, where land is used for solar energy production and agriculture, the panels provide clean energy while also shading plants from excessive sunlight. Pollinator-friendly plants can improve water quality and reduce soil erosion by obstructing the wind.

If two strands of conducting materials are connected at two junctions, electricity can be generated if one junction is heated while the other is cooled—a phenomenon known as the Seebeck effect.

Learn about endoliths, the polyextremophiles that thrive inside rocks

These organisms include species that live in Antarctica, where they perform photosynthesis using light and water that makes it through pores in sandstone. Others residing in Earth's crust can survive temperatures reaching 60 degrees Celsius (140 degrees Fahrenheit) while generating energy through chemical reactions involving nutrients and gases trapped in rocks.

Explore a gallery of Bill Nye's energy-efficient home

The Southern California home is painted pale yellow and features double-pane, low-emissivity glass windows to help keep temperatures low. Solar panels are used for electricity and hot water, while Solatube domes and ducts illuminate rooms from above throughout the day, even when the sun is low in the sky.

Climate resilience strategies, which help communities mitigate the effects of climate change, include painting roofs white, building clam gardens, harvesting fog, and feeding cows seaweed.

When users prompt AI chatbots, both cooling systems that support data centers and power plants that rely on steam cycles to generate electricity for data centers contribute to water use.

High-altitude kites can perform airborne collection of energy from high-speed winds

Winds at high altitude are stronger and more consistent than those near Earth's surface, where natural and artificial barriers disrupt airflow. Kites pulled by the wind can extend a tether like a yo-yo, creating electricity in an attached ground generator.

Windmills can be designed to pump groundwater for irrigation or land drainage

A gearbox within the windmill converts the windmill's rotation into the vertical motion of a piston that pushes water up a pipe. It also drives the rotation of an Archimedes screw to move water to higher elevations.

Landfills capture methane gas and convert it into usable energy

As organic waste breaks down underground, it produces landfill gas that is roughly 50% methane. That gas can be captured and used to generate electricity or provide heat for nearby homes and businesses.

Wind turbines explained

Wind turbines have powered homes since 1887, and today they’re stronger, quieter, and more reliable than ever. Offshore wind could power millions and grow fast enough to meet climate goals.

A basement of mechanical systems—collectively called the technosphere—supports B2

Twenty-six underground air handlers heat, cool, filter and manage the humidity of the air across the biomes of Biosphere 2. The above-ground Energy Center complex provides continuous power to these and other systems, including heating and cooling water for laboratory experiments and personal use.

Salt is harvested from briny ocean water and underground deposits

Mostly sodium chloride, this compound is produced for human use by collecting seawater in shallow pans and allowing the Sun to evaporate the water until crystals remain. Underground rock salt is mined, crushed, and purified from deposits left behind by ancient seas that have dried-up.

As of 2025, wave power projects remain in early research and testing phases

Waves can become a steady source of renewable energy because they do not pause like wind and solar power do. However, funding gaps and the effects of storms, salt exposure, and biofouling—mussels and other sea creatures attaching to wave machines—have presented challenges in scaling the technology beyond testing sites.

Electric grids that rely on solar power must compensate for reduced electricity generation during solar eclipses.

Nuclear batteries generate electrical currents using radioactive materials

Rather than using electrochemical reactions to produce the electrons that flow through a circuit, isotopes like nickel-63 undergo beta decay—emitting electrons—which a semiconducting material can absorb to establish a charge imbalance that generates current. Such batteries could provide low-power energy for decades.

In nuclear reactors, water acts as a coolant and moderator, slowing neutrons produced in nuclear reactions so they are more likely to interact with nuclear fuel and generate sustainable energy.

Dust particles on Mars can generate lightning

Through triboelectric charging, sand and dust on the Martian surface can become electrified when they rub against one another, causing friction to displace electrons and create charged particles. If this matter forms a strong enough electric field, it can overcome atmospheric insulation and produce electrical discharges, resembling lightning on Earth.

Explore options for recycling batteries

Improper battery disposal can lead to fires and the leaching of harmful chemicals and toxic materials into local soil and water systems. Although many batteries contain metals that can be recycled with less energy than it takes to produce them, variability in regulations across municipalities and states can complicate efforts. (Some readers may experience a paywall.)

Electricity is produced when the ends of a battery are connected by a conducting wire, triggering chemical reactions that release the energy stored in chemical bonds.

Establishing the wind power grid required incentives, reliability, and affordability

Although wind was harnessed to generate electricity for individual buildings in the late 1800s, high costs, mechanical issues with turbines, and better fossil-fuel alternatives delayed wind power's widespread growth. After the oil crises of the 1970s, governments sought alternative energy sources and, in the decades that followed, provided tax credits to expand the wind power market.

Rain-catching tubes provide new hydropower source for tropical regions

An experiment in Singapore showed that charge separation could be established by rainwater flowing through narrow tubes. The separation, which creates a voltage, could be scaled up in regions of high rainfall to provide a clean energy source.